From the Archives: The Clutch Enema

This article is reproduced from an earlier Allard Owners Club magazine as a piece of club history and humour.

Please do not treat it as current technical advice. The method described reflects one owner’s improvised solution at the time and is reproduced here for historical interest only. Anyone dealing with clutch contamination or gearbox oil leaks today should use appropriate workshop procedures and seek suitable technical advice where necessary.


Part of THE FLATHEAD “BODGERS GUIDE”

We were requested to have a series on “botches”. Here is the first, but we now rely on you the reader to supply further examples.

It is three days before Prescott Hill Climb, you cannot get a minute off work and you’ve got chronic clutch slip. There is oil leaking from the front gearbox seal.

No time to change a clutch, let alone get one from Wally. So . . . .

Drill a ¼ inch hole in the side of the tin part of the bell housing. Fill a two litre plastic bottle with boiling water and washing up liquid. Under no circumstances return the Fairy to its normal place by the sink – your spouse will think you’ve gone soft. Make a hole in the cap of the bottle and stick a length of ¼ inch rubber pipe in it. Stick the other end of the rubber pipe on the bell housing and squeeze. Oooohh . . .

Start the engine and depress the clutch pedal. Five minutes later, one nice clean, oil-free clutch and a front garden full of bubbles!

Three months and a thousand miles later, still no clutch slip.

The sophisticated flat head owner will use Ariel biological low-suds automatic.

Mark Brett

Ed. Note. Do you have a favourite bodge? Please share it with us, we would like to continue the series.